Recent content by Animalector

well you don't have to worry about which foot is forward ;-)

Shipped including GST with local support including Bafang parts, its not so bad 🤔

Thanks for that I'll have a read.. cheers Andy

So we're discussing the facts?? :unsure: I'd like to read some of this, please post a link perhaps rather than typing it again.. Perhaps a link to the GITHUB?? Cheers,

Fangbikes has australian stock of frames.... Fang Bikes

I think this is a good discussion, I'm looking at the current Australian Standards for reference.. Firstly, AS15194-2016 still allows for mechanical measurement of power in Annex D by measureing speed over 20m and applying a forumla to calculate power. I'm also using AS 60031-1 which is...

Well actually the international standard is pretty prescriptive about how to measure 250W nominal.. nowhere does it say anything about burning motors out. not that I can recall reading anyway. so having an M600 chassis, so long as it meets the requirements of the international standard would...

Thanks for the advice, I agree sometimes you reset flags through a firmware reset. However, the actual reported current was 2.5A in the controller, whereas the reported current from the Battery was 40mA. If you take the Battery current as truth, there is something happening to make the...

Error 27 is Controller over current With the Besst Tool.. This looks like the "Controller Current" reporting around 2.5A, but actually the "battery current" only reports around 40mA (idle on the bench). Option 1 - Try reflashing the firmware - This worked for me once. for around 3 months, and...

Yeah I think it was a one off. Most likely damaged in transit and I didn't realise before install.

MY.guess would be software detuned M600 so that customers can just firmware patch it later on their own much in the same way they deregulate motorcycles to comply with learner limits. It's what I would do

Too close may also give erratic results. So just be aware of that. The manual says >5 and <25mm

More companies are bringing out ebikes but prices are going up and up. Even Analogue MTB prices are going through the roof. It's a trend..

actually that's not true.. the cassette bent teeth first ride, so I am using a shimano 10sp cassette, but otherwise the shifter and derailleur have been quite good.

frame is the same, there is adequate clearance for 29 x 2.4 and 27.5 x 2.8