The “What did you break today?” thread

[Gary]

whatever that’s supposed to mean

Pounds (force) per square inch (area)
Basically what stress the vice can withstand

 

[MrSimmo]

Pro tip:
Next time remove the axle and non driveside bearing (attached) BEFORE putting the wheel in the vice mounted ratchet tool.

You're welcome.

Good call

 

[Rich-EMTB-UK]

mangled the XX1 chain, managed to get the pins out and stick another speed link in with the help of the one-up tool and most importantly a rag to hold the bloody tool still while I unscrewed the pins out of the chain. Otherwise it would have been a long push and roll back to the car.

 

[ant0]

A few weeks ago.... LBS found a sheared a non replaceable Bosch motor mount on my 1 year old Cube when replacing a cable under warranty..... Luckily Bosch covered it under warranty and I had a new free motor supplied and fitted in just over a week

I'd put over 2000 miles on the motor in year one, so nice to get a fresh zero miles one for free

 

[Nakiri]

Again...

 

[Hamina]

I think I my rear cassette Tried to climb a steep short hill with absolutely high cadence -> Bosch stopped assisting -> MAYBE there was a gear change I don't know.

Anyway there's zero possibility that it could have been just the NX-cassettes weakness in normal use.

 

[GeorgesEBike]

Last week I stripped the motor bolt holes on my brand new Heckler. Today I blew out the bladder on my brand new Magura MT7 brakes. I'm 0-3 with Magura brakes. Swapping them out for the SRAM Code RSC's.