Recent content by Japuserid

  1. Japuserid

    E8000 "bottom bracket" bearing play after 1400km

    Cheap and simple magnet fix, has worked well and never let me down.
  2. Japuserid

    Ducati and Thok bikes partner on to create Ducati MIG-RR

    Oh mien got!!!!!! Ducscati :love::love::love::love::love::love::love::love::love::love:
  3. Japuserid

    Tube or Tubeless?

    Hi @Swissrob Not so sure that you were given good advice really? IMHO you would be needing to run at silly low pressures to risk any real problems, I have unintentionally run as low as 6 psi on the rear and got away with it. As long as your tire width is proportional to your rim width and...
  4. Japuserid

    Waterproof Flat MTB shoes

    Hi Gary Believe it or not I really don't think I have ever worn skate shoes :unsure: but I do know what you mean about changing foot position. My previous High Impact Five ten's and the soft Stealth sole with a standard pin on V12's was too much for me, it required a real effort to lift and...
  5. Japuserid

    Waterproof Flat MTB shoes

    Waterproof flat sole shoes like these perhaps :unsure: Been using these for about 10 months now and I :love: them. Waterproof, comfortable with a decent bit of support and protection. I have mated them to a set of V12's with extra long pins and it works really well. Had Five tens High...
  6. Japuserid

    E010 followed by W013

    Hi @eagerly Brilliant thank you (y)
  7. Japuserid

    E010 followed by W013

    Hi @eagerly Thanks for your reply to my post, really appreciated. My problem, I am hoping at least, :unsure: appears to be dirty connections and the bike is currently running like a dream, :whistle: done another 10 since my original post and done everything I can to upset it but it seems...
  8. Japuserid

    E010 followed by W013

    E8000 motor is now 6 months old and done approximately 1200 miles and recently I have experienced a series of E010 errors and finally to a complete shutdown and constant W013 warning. First time was about 2 weeks ago, after riding all morning with Kernow, without any faults as i restarted after...
  9. Japuserid

    So it's starting to annoy me....

    Hi @Bongofish Creaking, as you put it, more often than not is simply the result of something being worn, seized or more likely loose. This is especially common on new bikes and just requires you to go around all the various components and make sure they are properly lubricated, if needed and...
  10. Japuserid

    SRAM EX-1 EMTB Drivetrain, reviews?

    Worth a look if you are having setup issues with EX1, disregard the title it's actually EX1 specific. How to Correctly Adjust the Rear Derailleur on Your E-mountainbike | E-MOUNTAINBIKE Magazine
  11. Japuserid

    SRAM EX-1 EMTB Drivetrain, reviews?

    Hi @Knobby, It is possible for them to have set the gap using the Sram tool and B tension screw if they deflate the shock so that it sits at the 30% sag mark during the setting process. I use this method and I find it certainly helps get you in the ball park, but unfortunately not the whole way...
  12. Japuserid

    Battery Health

    Hi @MattyB , I am quite sure you are absolutely correct in that the firmware does protect the battery from any damage caused by excessively discharged cells, certainly in the short term, but the point I was trying to make, was that leaving it flat for a length of time thereafter is simply not...
Top